Now the covers are done constructively .
Just as she now has to come out of the printer you but first remove the support Struck doors, which is not so difficult but .
To do this simply pushes a knife or a thin screwdriver under it and levering it on the sides , piece by piece from . The PLA used then breaks off brittle.
And so do the insides without these supporting structures.
If you then have the space in the tank , you can simply back the covers , like start in this picture and simply clip it with a little caution to the front.
Unfortunately, it will not be when the transmission queue directly on the front possible in all Hull. Since one must then match the best cut off the front, with a small blade.
And this is what the covers then the transmissions from now .
And here I have put them in a KV- bath times.
